• 1
  Power up your device
  Plug Bus Aunty into a USB-C power adapter. The screen will flash (black to white) and show the WiFi setup screen.

  💡 Pro Tip

  Make sure the USB-C cable is securely connected. The screen flash indicates the device is starting up properly.

• 2
  Connect to Bus Aunty WiFi
  On your phone or computer, go to WiFi settings and connect to the network called "Bus Aunty"
• 3
  Open the Wi‑Fi setup page
  In your browser, navigate to: 1.2.3.4
  You should see Bus Aunty WiFi Setup and a list of available networks.
• 
  
  
• 4
  Configure WiFi & Bus Stops
  Tap your home network, then enter:

  • a
    Your home WiFi password
  • b
    Optional bus stops — up to 4. Codes are 4–5 digits (like 4121 or 04121); names are up to 12 characters (e.g., "Home", "Office", "School"). You can leave these blank and set them later.

  💡 Finding Bus Stop Codes

  Bus stop codes are displayed on the physical bus stop signs, or you can find them in the MyTransport.sg app.

• 5
  Connect & Enjoy!
  Tap Connect and wait for the device to refresh. It will join your Wi‑Fi and show live bus arrival times. Bus stops are optional on this screen.
  

Need to update your bus stops or add new ones? Here are two easy methods:

Method 1: Using the Web Config Page(Recommended)

• 1
  Turn the device off and on again (Power Cycle)
  Make sure your phone/computer is connected to the same WiFi network as Bus Aunty.
• 2
  Open configuration page
  In your browser, go to: bus-aunty.local
• 3
  Update settings
  The settings page shows a Screen preview with a stop on the left and right. Change stop codes and on-screen names, or limit which buses appear.

  🎛️ Bus Service Filtering

  To show only specific buses, enter bus numbers separated by commas:
  73,55,269A,410W

Method 2: Hard Reset

• 1
  To access the reset button
  Remove the rear cover, do it slowly to not damage the electronics inside.
• 
• 2
  While the device is plugged in. Double press the Boot Button
  You should see the Bus Aunty screen flash to the main setup page. If the screen does not flash, try again. Remember it can only reset WHILE the device is plugged in and has power. 
• 
• 3
  Reconfigure
  Follow the first-time setup process again to reconfigure all settings.

• 📺
  Display Layout
  Bus Aunty shows 2 bus stops at a time, cycling through all configured stops.
• 🔄
  Refresh Rate
  Bus information updates every 30 seconds with real-time data from LTA.
• 🚌
  Bus Services
  All bus services for each stop are displayed, unless you've set up filtering.

• ❓
  Device showing weird numbers?
  This happens when the device can't reach the time server. Simply unplug and plug back in.
• 📡
  No bus data showing?
  Check your WiFi connection and ensure bus stop codes are correct (4-5 digits).
• 🔧
  Need to factory reset?
  Remove the back cover with a flat screwdriver and press the "BOOT" button twice.